Made a trip to Waitoa today to visit Lucy and her new Gen-2 PB4. This machine is a game changer for Pre-Breakers with its ability to cut bone and soft products like face pieces and other challenging products. This was personalised just for Lucy. Check out the sticker on the side. 😉👍 ... See MoreSee Less
I don't miss working on those. I think the one in the basement at Tomona was the worst. It had to be taken out in pieces over the pipework. I prefer aeroplanes !
The Dahlih Mill getting the job done 🫡 ... See MoreSee Less
Comment on Facebook
The end result is a shear pin that has been milled down to 280mm, still weighing in at 900kgs 😱
Good job
Merry Christmas from the Team at NEC, and have a Happy New year 🥳 ... See MoreSee Less
Comment on Facebook
Happy Merry Christmas 🎁
Merry Christmas and happy 2025
Using a customer’s sample we made two shiny new ones; these two trunion rollers are ready to roll 👍🏼 ... See MoreSee Less
Comment on Facebook
Flash!
Made a trip to Waitoa today to visit Lucy and her new Gen-2 PB4. This machine is a game changer for Pre-Breakers with its ability to cut bone and soft products like face pieces and other challenging products. This was personalised just for Lucy. Check out the sticker on the side. 😉👍 ... See MoreSee Less
Comment on Facebook
Kinda miss rebuilding the old PB4
Good job
Been keeping Gordie busy this week with a few unusual machining challenges. ... See MoreSee Less
Comment on Facebook
Top man Gordy!
Gordon Hodges lol
A few of the team keeping busy in the machine shop with some rather sizable hunks of steel ... See MoreSee Less
Comment on Facebook
Great job
A few more new Pre-breakers enjoying the Hawkes Bay sun while waiting to be stickered up. 😉 ... See MoreSee Less
Comment on Facebook
I don't miss working on those. I think the one in the basement at Tomona was the worst. It had to be taken out in pieces over the pipework. I prefer aeroplanes !
A quick repair done here today with metal spraying to provide a new surface for seals to run on. ... See MoreSee Less
Comment on Facebook
I used to do that at sea 25 years ago lol
Great job👍👍
A few not so small hydraulic bits in for machining. ... See MoreSee Less
Comment on Facebook
Lathe Machine work